AW: Trockener Bass bis in den Keller?
wenn die tröten bassreflex sind, stopf die öffnungen zu, wird zwar kaum was helfen aber sicher ist sicher.
ansonsten ist das mit der gruppenlaufzeit ein hund, aber im raum kommen so viele faktoren zusammen ... dass ich mich da nicht festzulegen traue.
trotzdem versuch mal 18db flankensteilheit, leg die übernahmefrequenz minimal auseinander (welche filtercharakteristik? bei butterworth etwas auseinanderlegen), spiel mit der phase. versuch macht kluch.
ein mulmiger bass vom sub "kann" sehr wohl oberbass maskieren. soll heißen, das zu laute mulmige überdeckt teile des oberbasses. dort, wo der bass sozusagen die härte herbekommt.
hochpass beim sub schiebt die gruppenlaufzeit noch einmal, nicht immer optimal. besser einfach weniger pegel.
zitat
"The subjective effect of excessive group delay is a “loosening” of the bass or a “less dry” bass quality. Currently there is insufficient psychoacoustic research on the threshold of group delay at low frequencies. One value is known: 2.5 ms at 100 Hz.
Adding infrasonic (high pass) filters to give very low-frequency driver protection adds to the group delay shown in the above plots. For example, a sealed cabinet with a second-order infrasonic driver protection filter with a corner frequency the same as the low-frequency cut-off of the loudspeaker will have the same group delay performance as a vented cabinet with the same low-frequency cut-off and no infrasonic driver protection filter.
Adding a subwoofer to a compact sealed loudspeaker increases the group delay slightly around the crossover due to the bass management crossover filtering - see graphs below around the 100 Hz region. As mentioned above, around the low-frequency cut-off of the main loudspeaker, the group delay is about the same with or without the subwoofer due to the very deep low-frequency cut off of the subwoofer. Below this the group delay continues to rise in the subwoofer as one would expect."
wenn die tröten bassreflex sind, stopf die öffnungen zu, wird zwar kaum was helfen aber sicher ist sicher.
ansonsten ist das mit der gruppenlaufzeit ein hund, aber im raum kommen so viele faktoren zusammen ... dass ich mich da nicht festzulegen traue.
trotzdem versuch mal 18db flankensteilheit, leg die übernahmefrequenz minimal auseinander (welche filtercharakteristik? bei butterworth etwas auseinanderlegen), spiel mit der phase. versuch macht kluch.
ein mulmiger bass vom sub "kann" sehr wohl oberbass maskieren. soll heißen, das zu laute mulmige überdeckt teile des oberbasses. dort, wo der bass sozusagen die härte herbekommt.
hochpass beim sub schiebt die gruppenlaufzeit noch einmal, nicht immer optimal. besser einfach weniger pegel.
zitat
"The subjective effect of excessive group delay is a “loosening” of the bass or a “less dry” bass quality. Currently there is insufficient psychoacoustic research on the threshold of group delay at low frequencies. One value is known: 2.5 ms at 100 Hz.
Adding infrasonic (high pass) filters to give very low-frequency driver protection adds to the group delay shown in the above plots. For example, a sealed cabinet with a second-order infrasonic driver protection filter with a corner frequency the same as the low-frequency cut-off of the loudspeaker will have the same group delay performance as a vented cabinet with the same low-frequency cut-off and no infrasonic driver protection filter.
Adding a subwoofer to a compact sealed loudspeaker increases the group delay slightly around the crossover due to the bass management crossover filtering - see graphs below around the 100 Hz region. As mentioned above, around the low-frequency cut-off of the main loudspeaker, the group delay is about the same with or without the subwoofer due to the very deep low-frequency cut off of the subwoofer. Below this the group delay continues to rise in the subwoofer as one would expect."
Kommentar